Water Spot Sensorto detect presence of water on surfaces
to detect presence of water on surfaces
key sensor features
The water spot sensor is used in applications where you want to detect floods. Whenever water fully covers the 2 rods, the sensor is triggered. It is typically used in applications to monitor if water has reached a certain level.
For critical areas where no water is allowed we do offer our water leak sensor. This sensor will trigger an alert whenever water makes contact with the cable, even a small amount.
To avoid corrosion, make sure to immediately dry the rods after an alert has been triggered.
- compact plug & play sensor.- designed for indoor use.
- steel enclosure.
- industrial grade.
- 0u rack, DIN rail or wall mountable sensor.
- plugs into the base unit.
- powered by the base unit.
- alerts via SNMP Traps, email or SMS.
- wired or optionally wireless.
- integrates via Modbus TCP, SNMP, JSON with other systems.
- integrates over RS-485 using Modbus RTU with ICS. Requires optional add-on.
No PC or Software Required
The InfraSensing sensors connect to the base unit (BASE-WIRED). The base unit is a standalone device that has its own IP address in your network. On its own it will monitor the sensor and trigger alerts via email, SNMP or optional SMS when needed.
There is no software or PC required for the sensors to run.
With our optional Monitoring Software you can centrally monitor sensors with trending and more. This is optional and not required.
Wired or Wireless
By default all sensors are connected to the SensorGateway (BASE-WIRED) using a CAT6 or higher RJ45 cable.
Using the optional Wireless Hub & Node modules, any sensor can be turned into a wireless sensor.
Wireless Hub & Nodes
Using the optional Wireless Hub & Node modules, any sensor can be turned into a wireless sensor.
Wireless Hub & Nodes