Phosphine (PH3) Gas Sensor
key sensor features
- measures phosphine gas concentrations up to 20ppm- resolution: 0.1ppm
lab calibrated against ozone reference gas
- 2 year life span
- sensors for 20+ other gas types
- compact plug & play sensor.
- designed for indoor use.
- steel enclosure.
- industrial grade.
- 0u rack, DIN rail, magnetic or wall mountable sensor.
- plugs into the base unit.
- powered by the base unit.
- alerts via SNMP Traps, email or SMS.
- wired or optionally wireless.
- integrates via Modbus TCP, SNMP, JSON or optional MQTT.
- integrates over RS-485 using Modbus RTU. Requires optional add-on.
Partial discharges (PD)
for medium voltage switchgears
The corona discharge is one of the main causes of medium voltage (MV) switchgear equipment failure, ageing and losses in a stable power system supply. It often goes undetected until the next manual inspection.
Next to inspections, companies today rely on electromagnetic and ultrasonic methods to detect PD. Those solutions suffer from interference and high costs.
Less known is that partial discharges resulting from the Corona effect, generate ozone gas. By digitally monitoring ozone gas levels in MV switchgear, PD events can be detected and alerts can be generated to maintenance staff for immediate inspection.
Next to inspections, companies today rely on electromagnetic and ultrasonic methods to detect PD. Those solutions suffer from interference and high costs.
Less known is that partial discharges resulting from the Corona effect, generate ozone gas. By digitally monitoring ozone gas levels in MV switchgear, PD events can be detected and alerts can be generated to maintenance staff for immediate inspection.
calibration & bump testing
Prior to shipping every gas sensor is manually tested in our lab against calibrated gas.
For bump testing we offer the optional SPARE-GAS-BUMP adapter which is mounted on to the sensor. It enables you to self test the sensor at intervals to ensure its operation within your own safety & operational requirements. Do note that each bump test impacts the sensor life span and accuracy. Incorrect bump testing may permanently damage the sensor.
For bump testing we offer the optional SPARE-GAS-BUMP adapter which is mounted on to the sensor. It enables you to self test the sensor at intervals to ensure its operation within your own safety & operational requirements. Do note that each bump test impacts the sensor life span and accuracy. Incorrect bump testing may permanently damage the sensor.
modular architecture
A modular architecture enabling you to integrate it with your on-premises monitoring systems using IP based industrial protocols like Modbus TCP and SNMP. Optional add-on to connect sensor data to a Modbus RTU controller. With our optional and special firmware the base unit can connect to a MQTT provider of your choice.
With the output controls of the SensorHub, the system can on its own take corrective actions when threshold levels have been detected. For example you can start a fan as soon as a specific is detected.
With the output controls of the SensorHub, the system can on its own take corrective actions when threshold levels have been detected. For example you can start a fan as soon as a specific is detected.
No PC or Software Required
The InfraSensing sensors connect to the base unit (BASE-WIRED). The base unit is a standalone device that has its own IP address in your network. On its own it will monitor the sensor and trigger alerts via email, SNMP or optional SMS when needed.
There is no software or PC required for the sensors to run.
With our optional Monitoring Software you can centrally monitor sensors with trending and more. This is optional and not required.
Wired or Wireless
By default all sensors are connected to the SensorGateway (BASE-WIRED) using a CAT6 or higher RJ45 cable.
Using the optional Wireless Hub & Node modules, any sensor can be turned into a wireless sensor.
Wireless Hub & Nodes
Using the optional Wireless Hub & Node modules, any sensor can be turned into a wireless sensor.
Wireless Hub & Nodes